Protocol 26195: Separated MCA Assay - Dp(16Tiam1-Kcnj6)6Yey
Version 1.2

Notes

Assay received from:

Y. Eugene Yu, Ph.D.
Department of Cancer Genetics
Center for Genetics and Pharmacology, Rm 2320
Roswell Park Cancer Institute
Elm and Carlton Streets
Buffalo, New York 14263

The genotyping protocol(s) presented here have been optimized for reagents and conditions used by The Jackson Laboratory (JAX). To genotype animals, JAX recommends researchers validate the assay independently upon receipt of animals into their facility. Reaction cycling temperature and times may require additional optimization based on the specific genotyping reagents used.

Expected Results

Targeted Mutation (duplication) = ~ 560

Internal postive control = 324 bp

 

Dp        Tm = 86    Area = 36      Tm =  91  Area = 20

IPC      Tm = 82    Area = 62

 

This is a targeted mutation (duplication) with no wild type-specific assays.  Homs are lethal so only WT or het is possible.

JAX Protocol

Protocol Primers

Primer 5' Label Sequence 5' → 3' 3' Label Primer Type Reaction Note
15360 CAA CGC GGC CTT TTT ACG Mutant Forward B
15457 GCC CTT CCC ACC CCA ATC Mutant Reverse B
oIMR7338 CTA GGC CAC AGA ATT GAA AGA TCT Internal Positive Control Forward A
oIMR7339 GTA GGT GGA AAT TCT AGC ATC ATC C Internal Positive Control Reverse A

Reaction A

Component Final Concentration
ddH2O
Kapa 2G HS buffer 1.30 X
MgCl2 2.60 mM
dNTPS-kapa 0.26 mM
oIMR7338 0.50 uM
oIMR7339 0.50 uM
Glycerol 6.50 %
Dye 1.00 X
Kapa 2G HS taq polym 0.03 U/ul
DNA

Cycling

Step Temp °C Time Note
1 94.0 --
2 94.0 --
3 65.0 -- -0.5 C per cycle decrease
4 68.0 --
5 -- repeat steps 2-4 for 10 cycles (Touchdown)
6 94.0 --
7 60.0 --
8 72.0 --
9 -- repeat steps 6-8 for 28 cycles
10 72.0 --
11 10.0 -- hold
JAX uses a very high speed Taq (~1000 bp/sec), use cycling times recommended for your reagents.
JAX uses a 'touchdown' cycling protocol and therefore has not calculated the optimal annealing temperature for each set of primers.

Reaction B

Component Final Concentration
ddH2O
Kapa 2G HS buffer 1.30 X
MgCl2 2.60 mM
dNTPS-kapa 0.26 mM
15360 0.50 uM
15457 0.50 uM
Glycerol 6.50 %
Dye 1.00 X
Kapa 2G HS taq polym 0.03 U/ul
DNA

Cycling

Step Temp °C Time Note
1 94.0 --
2 94.0 --
3 65.0 -- -0.5 C per cycle decrease
4 68.0 --
5 -- repeat steps 2-4 for 10 cycles (Touchdown)
6 94.0 --
7 60.0 --
8 72.0 --
9 -- repeat steps 6-8 for 28 cycles
10 72.0 --
11 10.0 -- hold
JAX uses a very high speed Taq (~1000 bp/sec), use cycling times recommended for your reagents.
JAX uses a 'touchdown' cycling protocol and therefore has not calculated the optimal annealing temperature for each set of primers.

Strains Using This Protocol

This is the only strain that uses this protocol.