Protocol 30043: QPCR Assay - Tg(H2-K-HLA-G,B2M)1Alm
Version 3.0

Notes

Taqman qPCR protocols are run on an ABI 7500, 7700, 7900 or the Roche LightCycler 480. Use an appropriate instrument-specific Fuorophore/Quencher combination.  The transgene genotype is determined by comparing ΔCt values of each unknown sample against known homozygous and hemizygous controls, using appropriate endogenous references.
The genotyping protocol(s) presented here have been optimized for reagents and conditions used by The Jackson Laboratory (JAX). To genotype animals, JAX recommends researchers validate the assay independently upon receipt of animals into their facility. Reaction cycling temperature and times may require additional optimization based on the specific genotyping reagents used.

Expected Results

JAX Protocol

Protocol Primers

Primer 5' Label Sequence 5' → 3' 3' Label Primer Type Reaction Note
9866 AGA GGA GAC ACG GAA CAC CA Transgene Forward A
9867 CAC TGG CCT CGC TCT GG Transgene Reverse A
9868 Fluorophore-1 CAC GCA CAG ACT GAC AGA ATG AAC CTG Quencher-1 Tg Probe
oIMR1544 CAC GTG GGC TCC AGC ATT Internal Positive Control Forward A
oIMR3580 TCA CCA GTC ATT TCT GCC TTT G Internal Positive Control Reverse A
TmoIMR0105 Fluorophore-2 CCA ATG GTC GGG CAC TGC TCA A Quencher-2 IC Probe

Reaction A

Component Final Concentration
Kapa Probe Fast QPCR 1.00 X
ddH2O
9866 0.40 uM
9867 0.40 uM
oIMR1544 0.40 uM
oIMR3580 0.40 uM
Tg Probe 0.15 uM
IC Probe 0.15 uM
DNA

Cycling

Step Temp °C Time Note
1 95.0 --
2 95.0 --
3 60.0 -- repeat steps 2-3 for 40 cycles
JAX uses a very high speed Taq (~1000 bp/sec), use cycling times recommended for your reagents.

Strains Using This Protocol

This is the only strain that uses this protocol.