Stock No: 002508
Protocol 22261: Standard PCR Assay - Plat<tm1Mlg>
Version 1.3
Notes
This assay does not work well without the use of a Hotstart (We are using Taq Start Antibody mixed 1:1 with Taq polymerase).
The genotyping protocol(s) presented here have been optimized for reagents and conditions used by The Jackson Laboratory (JAX).
To genotype animals, JAX recommends researchers validate the assay independently upon receipt of animals into their facility.
Reaction cycling temperature and times may require additional optimization based on the specific genotyping reagents used.
Expected Results
Mutant=280 bp
Heterozygote = 1500 bp and 280 bp
Wild type=1500 bp
Heterozygote = 1500 bp and 280 bp
Wild type=1500 bp
Separated by gel electrophoresis on a 1.5% agarose gel.
JAX Protocol
Protocol Primers
| Primer | 5' Label | Sequence 5' → 3' | 3' Label | Primer Type | Reaction | Note |
|---|---|---|---|---|---|---|
| oIMR0474 | TGC CAT GTG ATG AAG GAC C | Wild type | A | |||
| oIMR0475 | AGC AGG AAC TGA TCA GCA CC | Wild type | A | |||
| oIMR6916 | CTT GGG TGG AGA GGC TAT TC | Mutant Forward | A | |||
| oIMR6917 | AGG TGA GAT GAC AGG AGA TC | Mutant Reverse | A |
Reaction A
| Component | Final Concentration |
|---|---|
| ddH2O | |
| Kapa 2G HS buffer | 1.30 X |
| MgCl2 | 2.60 mM |
| dNTP KAPA | 0.26 mM |
| oIMR0474 | 0.50 uM |
| oIMR0475 | 0.50 uM |
| oIMR6916 | 0.50 uM |
| oIMR6917 | 0.50 uM |
| Glycerol | 6.50 % |
| Dye | 1.00 X |
| Kapa 2G HS taq polym | 0.03 U/ul |
| DNA |
Cycling
| Step | Temp °C | Time | Note |
|---|---|---|---|
| 1 | 94.0 | -- | |
| 2 | 94.0 | -- | |
| 3 | 65.0 | -- | -0.5 C per cycle decrease |
| 4 | 68.0 | -- | |
| 5 | -- | repeat steps 2-4 for 10 cycles (Touchdown) | |
| 6 | 94.0 | -- | |
| 7 | 60.0 | -- | |
| 8 | 72.0 | -- | |
| 9 | -- | repeat steps 6-8 for 28 cycles | |
| 10 | 72.0 | -- | |
| 11 | 10.0 | -- | hold |
JAX uses a very high speed Taq (~1000 bp/sec), use cycling times recommended for your reagents.
JAX uses a 'touchdown' cycling protocol and therefore has not calculated the optimal annealing temperature for each set of primers.